bookmark_borderbookmark

ABS-Lock III-BE

Anchorage point - designed for hammering into a concrete subsurface
Grafik des im Betonuntergrund verankerten Sekuranten ABS-Lock III-BE.
Employee working on the roofs edge attached to a ABS-Lock III-BE fall protection anchor
The ABS-Lock III-BE is a single point anchor that can be installed in a matter of minutes.

Product information ABS-Lock III-BE

This stainless steel anchorage point (Ø 16 mm) - specially designed for flat roofs with a concrete surface - is simply hammered into a clean bore hole. The special, integrated dowel ensures a firm and reliable hold in all directions of load. This anchor has been awarded national technical approval by the German Institute for Construction Technology (DIBt).

  • National technical approval ("abZ"): Z-14.9-688
    (pls. observe the installation instructions provided in the "abZ")
  • Ü symbol
  • EN 795:2012, A + CEN/TS 16415:2013
  • Concrete ≥ C20/25
  • Installed in just a few minutes
  • Accessories: Stainless steel installation aid to protect the thread
ABS-Lock SYS
Force Directions
Substructure
Max. no. of users
Miscellaneous
Attachment
Application

Find out more about our ABS-Lock III-BE

Fall arrest solution for flat roofs - with national technical approval (“abZ”)

Drill a hole, hammer in the anchor and your fall arrest device is ready. Use our ABS-Lock III-BE which has been specially designed for flat concrete roofs to considerably reduce the amount of installation effort required. You can install your anchorage point - which could also be used as a support in a lifeline system - in less than 2 minutes.

The ABS-Lock III-BE rod is 16 mm in diameter and manufactured from special stainless steel designed to buckle under stress. Our anchorage device not only gains points for being easy to install. It has also been granted national technical approval ("abZ") by the German Institute for Construction Technology (DIBt) -  a fact which leaves planners and the German employers' liability insurance associations totally happy with no further questions.

The standard ABS-Lock III-BE package includes a stainless steel anchorage eyelet which is simply screwed onto the upper thread. To protect the thread from damage when it is being hammered into place, our range of products also includes a special installation aid: Click here for more information on our ABS-Lock III-BE installation aid.

Accessories / Components

Stainless steel extension piece to protect an ABS-Lock III-BE anchor from accidental hammer damage

bookmark_borderbookmark

Extension piece for an ABS-Lock III anchorage point

bookmark_borderbookmark

Sealant collar for fall protection anchors installed on a bitumen roof surface (Ø 16 und 42 mm)

bookmark_borderbookmark

Sealant collar for anchorage points (Ø 16 and 42 mm) - specially designed for PVC, PP and PE roof surfaces

bookmark_borderbookmark

Thermal protective cover & signal rod for fall protection anchors

bookmark_borderbookmark
keyboard_arrow_up