bookmark_borderbookmark

ABS-Lock III-B

Anchor - specially designed for cementing into concrete subsurfaces
Grafik des im Beton verbauten Sekuranten ABS-Lock III-B.
Der Anschlagpunkt ABS-Lock III-B in Bewegung: Schauen Sie sich das kurze Produktvideo mit den wichtigsten Features an!
Fall Protection Anchor, installed using a special brass dowel.

Product information ABS-Lock III-B

This stainless steel anchorage point (Ø 16 mm) - designed to secure individuals - has been certified by the German Institute for Construction Technology (DIBt). It is installed in concrete using two-component adhesive and is suitable for installation on a roof surface or facade - on the ground, in a wall or overhead.

  • National technical approval ("abZ"): Z-14.9-688
    (pls. observe the provisions provided in the "abZ")
  • EN 795:2012, A + CEN/TS 16415:2013
  • Concrete ≥ C20/25
  • Recommended accessories: Special adhesive WIT-VM-250
  • Important: When the device protudes ≥ 100mm above the subsurface in a wall/facade lifeline system (corner or end support), an additional supporting tube is required

Find out more about our ABS-Lock III-B

ABS-Lock III-B anchor – the all-rounder for concrete

Our stainless steel ABS-Lock III-B anchor is a true all-rounder: It has been tested for all directions of load so that it can be used in floor, wall, facade and overhead installations. Thanks to having been awarded national technical approval by the German Institute for Construction Technology (DIBt), this anchor can be permanently attached to your building structure. Simply cement the anchor straight into your concrete surface using our special WIT-VM-250 adhesive. The stainless steel anchorage eyelet included in the package secures up to 3 individuals working at dangerous heights.

Our ABS-Lock III-B can be used as the basis for setting up a variety of different retention and fall arrest systems. It is equally suitable as a single anchorage point or as a support (wall/facade) in your lifeline system. Our Ø 16mm ABS-Lock III-B is designed to buckle under the impact of a fall so as to reduce the level of force exerted on the subsurface. To ensure that the rod is not accidentally bent whilst the lifeline system is undergoing the required pre-tensioning, we supply an optional supporting tube which provides adequate stability.

Accessories / Components

Stainless steel supporting tube for ABS-Lock III anchorage points

bookmark_borderbookmark

Special Adhesive for concrete and masonry

bookmark_borderbookmark

Sealant collar for fall protection anchors installed on a bitumen roof surface (Ø 16 und 42 mm)

bookmark_borderbookmark

Sealant collar for anchorage points (Ø 16 and 42 mm) - specially designed for PVC, PP and PE roof surfaces

bookmark_borderbookmark

Thermal protective cover & signal rod for fall protection anchors

bookmark_borderbookmark
keyboard_arrow_up